[Logo] GDE Forum - Home for the best in diesel powertrain tuning
  [Search] Search   [Recent Topics] Recent Topics   [Hottest Topics] Hottest Topics   [Top Downloads] Top Downloads   [Members] Member Listing   [Groups] Back to home page 
[Register] Register /  [Login] Login 
Bad Injector, need the injector code programmed  RSS feed
Forum Index » Product Questions
Author Message
bugnout
[Avatar]
Joined: 05/01/2010 22:09:32
Messages: 3
Offline
Ok, I've got a bad injector. FSM says I have to have the injector code programmed in via the scan tool.

I was planning on replacing the injector myself. Can I send my ECU to GDE and have the code updated, or should I take it to the dealer have them replace it, program the ecu via scantool and then send the ECU to GDE?

Would there be a charge for this? My ECU was one of the first GDE programmed when you started to offer this service.
GreenDieselEngineering
[Avatar]

Joined: 10/07/2009 07:25:47
Messages: 374
Location: Southeast Michigan
bugnout,

Since you were an early adopter having an updated tune will add some features anyway. You may be better off just sending it to us for the update and we can program the new injector code for you at the same time. The cost for this would be $30 to cover the shipping of returning the ECU to you.

If you go to the dealer, they should only change the injector code and not update your entire ECU code. However, we did not record the firmware versions of the ECU for the first few buyers and we do not know yours. If the firmware is early, the dealer is instructed to update it as standard protocol.

Thanks,

GDE
[WWW]
bugnout
[Avatar]
Joined: 05/01/2010 22:09:32
Messages: 3
Offline
Thanks, I'll send it in as soon as the injector arrives
moto-scoot

Joined: 17/08/2009 23:40:12
Messages: 2
Offline
I have 4 NEW factory sealed ones
 
Forum Index » Product Questions
Go to:   
Powered by JForum 2.4.1 © 2015 JForum Team • Maintained by Andowson.com